SPL Team forum, pictures, videos, builds, advice.
HomeCalendarFAQSearchMemberlistUsergroupsRegisterLog in

Share | 

 Big 3 Upgrade

Go down 

Posts : 123
Join date : 2009-12-06
Age : 31
Location : Durham

PostSubject: Big 3 Upgrade   Mon Dec 07, 2009 9:28 pm

First find your mounting spots. One on the frame and one on the engine block. Where exactly these 2 spots are is up to you.

The Frame

The Engine Block

And then the third spot, this one is not up to you....

Alternator Positive Output

Take 2 cables, with connector rings or terminals attached to both ends of both cables.

Take your first cable and hook up one of the ends to your spot on the frame,

Take your other cable and hook up one of the ends to the engine block spot,

Then you take the 2 lose ends of both cables and hook them both up to the negative post of your battery,

Now, with your third cable, you connect one end of it to the alternator positive output,

And the other end of the same cable, to the positive post of your battery,

And you are all done

Written up by Father Yuli

Last edited by Mat-Romain on Mon Dec 07, 2009 10:47 pm; edited 1 time in total
Back to top Go down
View user profile http://teamassholespl.forumotion.com


Posts : 139
Join date : 2009-12-07
Age : 41
Location : Ontario

PostSubject: Re: Big 3 Upgrade   Mon Dec 07, 2009 10:20 pm

Good threads! Should make them stickies.
Back to top Go down
View user profile
Big 3 Upgrade
Back to top 
Page 1 of 1
 Similar topics
» Fox Shocks Rebuild/Upgrade
» How to upgrade steering gears and tie rod?
» JR PCM9 Transmitter
» Upgrade ponderages...
» Eddie McGuire explains the new track

Permissions in this forum:You cannot reply to topics in this forum
Team Asshole SPL :: Audio DIY :: Basic Info DIY-
Jump to: